Prodew FogMist Block - Page 25

25
System Installation
4
2
Connect black tubing (minimum 4in
length)totheinlinelter.
Flushthelterforatleasttwominutes.
FLUSH THE CITY WATER LINE FOR
3-4 MINUTES BEFORE CONNECTING
TO OUR WATER LINE.
Thread black tubing (water inlet and
drain kit) into the water supply ball valve.
Applyteontapeasneeded.
IMPORTANT
Make sure to place the control box
near a power and water source.
FLUSH THE CITY WATER LINE FOR
3-4 MINUTES BEFORE CONNECTING
TO OUR WATER LINE.
Tools Required
Equipment Required
Tube Cutter
Drill
TeonTape
Misc Drill Bits
& Drivers
Adjustable
Wrenches
Chanel Lock
Pliers
Screw Drivers
1
3
Mount the solenoid box and the air
compressor under the display case.
Ensure both are strapped tightly to
avoid movement
Run the other end of the black tubing
from the water supply ball valve to the
shut-ovalveonthelter.
Cut tubing to length
NOTE: System is installed the same in Gravity and Forced Air Cases