Need help?Do you have a question about the PROEL AMP03 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Input Impedance | 20 kΩ |
| Frequency Response | 20 Hz - 20 kHz |
| Signal to Noise Ratio | > 100 dB |
| Input Sensitivity | 0.775V |
| Type | Class AB Integrated Amplifier |
| Damping Factor | >200 @ 8Ω |
| THD | < 0.1% |
Covers water, ventilation, and heat hazards. Ensure proper placement away from moisture and heat sources.
Addresses power source connection, grounding, polarization, and power cord protection to prevent electrical hazards.
Details cleaning methods and unplugging the unit for non-use periods to ensure longevity and safety.
Prevents object/liquid entry, ensures safe power line use, and guides unit relocation to avoid damage.
Prohibits user servicing. Outlines conditions requiring professional repair and limits user maintenance operations.
Tighten speaker wire screw terminals firmly. Do not defeat grounding connection for user safety.
Use manufacturer-suggested accessories. Place unit in rack, away from wet places, heat, and poor ventilation.
Keep unit away from sprinkling/drops. Do not place liquids on unit. Avoid small rooms or bookshelves.
Lists features like MIC inputs, PHONO/AUX input, LED indicator, level controls, tone controls, outputs, and priority function.
Identifies and lists controls: Power switch, Master volume, Tone controls, Input volume controls, Frequency equalizer.
Identifies and lists rear connections: Fuse-holder, AC power cord, Priority terminals, Speaker outputs, AUX/PHONO switch, MIC inputs.
Use shielded cables for microphones. Suggests unbalanced low impedance microphones (30-600Ω).
Connect CD players, tuners, etc., to AUX input. Selector switch chooses AUX or PHONO input.
Connect speakers to terminals. Avoid touching outputs when unit is on. Unit supports constant impedance and voltage speakers.
Connect COM to negative speaker post, positive to desired post (4, 8, 16Ω). Total impedance should match amplifier output.
Connect 100V to positive speaker side, COM to negative. Speakers need a transformer of the same voltage.
Short-circuiting PRIORITY terminals mutes MIC2, AUX, PHONO, giving MIC1 priority.
Press POWER switch to turn on/off. LED indicates power status.
Use BASS (150Hz), MIDDLE (1kHz), HIGH (6kHz) controls to adjust frequencies up to 10dB boost/cut.
Adjust MIC 1, MIC 2, AUX/PHONO levels independently and use MASTER volume for overall output.
To Next Page
