5.Installation
Connect RMW10 receiver to a mixer/amplifier, using the balanced or unbalanced output
Connect antenna, connect adaptor AC/DC to RMW10 and to the main power supply socket
Switch on the receiver
Insert the batteries in the transmitter and switch on.
There are 2 modes for operating frequency setting :
1) Select manually The same frequency on the receiver and on the transmitter (revert to paragraph 3 and 4)
2) Set manually the frequency on the transmitter (see paragraph 4) and proceed with automatic scan on the receiver ( revert to
paragraph 3)
Nota: In case of many wireless microphone systems operating contemporaneously, the automatic frequency receiver scan can set
the receiver frequency accordingly to another transmitter operating frequency. Continue then the scan to ensure the combination
selected: receiver of the system 1 coupled with the transmitter of the system 1 , receiver of system 2 coupled with transmitter of
system 2 etc.. .
6. Frequency Table (638.000-662.000MHZ)
In case several wireless microphone systems are operating contemporaneously
and in order to avoid interferences, use the following frequencies:
To Next Page
Loading...
