Need help?Do you have a question about the Profile Baja HA1000 and is the answer not in the manual?
Congratulates the user on purchasing a Baja amplifier and highlights its quality for musical reproduction.
Advises keeping the sales receipt safely for warranty service to establish the purchase date.
Recommends professional installation for optimal performance but guides self-installers on careful manual reading.
Covers critical safety measures like fusing, wire handling, careful mounting, signal wire routing, grounding, and avoiding sharp edges.
Details built-in crossovers, bass/treble boost, subsonic filter, phase control, high-level input, and RCA output.
Explains tri-mode operation, remote turn-on, adjustable sensitivity, impedance stability, fuse, and DC offset protection.
Describes short circuit protection, thermal protection, and the role of the protection indicator LED.
Instructs on connecting the positive terminal to the battery and ground terminal to the chassis using appropriate gauge wires.
Guides on connecting the REM terminal to a switched 12V source for amplifier power control.
Advises selecting a well-ventilated spot and exercising caution to avoid damaging vehicle components during mounting.
Explains connecting RCA outputs from the head unit to the amplifier, recommending proper wire routing to avoid noise.
Describes using high-level inputs for factory radios without RCA outputs, connecting directly to speaker outputs.
Details speaker connections for two-channel and four-channel amplifiers, emphasizing correct phasing and impedance.
Guides on bridging amplifiers for mono output, stressing the requirement of a 4 Ohm minimum load to prevent damage.
Explains how to run stereo satellites and a mono subwoofer simultaneously, detailing necessary settings and impedance loads.
Details setting the low pass crossover for subwoofers and using the bass boost control for enhanced low frequencies.
Guides on setting the high pass crossover for tweeters/midranges and using the treble boost for high frequencies.
Explains using the subsonic filter to remove inaudible low frequencies and phase control for optimal subwoofer blending.
Provides a step-by-step guide for setting the input gain to match the source unit's output without distortion.
Offers solutions for common problems like no output, low output, engine noise, and protection LED activation.
Presents comprehensive technical data for each amplifier model, including power ratings, frequency response, and dimensions.
Outlines the one-year warranty, its coverage, exclusions, and requirements for making a claim.
Details the procedure for returning a unit for warranty repair, including necessary documentation and contact information.
General| Bass Boost | 0 - 18 dB |
|---|---|
| Power Output | 1000W |
| THD at RMS Output | 0.05% |
| Impedance | 4 Ohms |
| Input Sensitivity | 200mV - 6V |
To Next Page