Operating Instructions
INSET 1 (for Step 3): SEPARATING SIZE AAel Capsules
a. The Body Ejector Stopper
stops motion of the Lifting Handle
after size AAel capsule
separation to prevent ejection of
capsule bodies from the Filler.
b. Before Separation (Step 3),
align front of Body Ejector
Stopper with back of Base Frame
as shown in the photo.
c. In Step 3, press the Lifting
Handle until it touches the Body
Ejector Stopper, then release it
slowly. After separation, remove
the Stopper Block before locking
the capsules.
4. Lift Caps Tray with the Push Plate slowly. 5. Set Caps Tray with Push Plate on table.
Slide Push Plate off Caps Tray to avoid lifting
caps due to static.
6. Place Caps Tray on Unseparated Capsule
Ejector Plate (a).
a
To Next Page
Loading...