3
GB
Notes before and during thermal binding:
• Place the machine on a steady and even place before using.
• Ready for binding will be signalized by fi rst buzz and by green working light.
• This signal will buzz every minute in order to show, that you can take out the docu-
ment and put it on to the cooling rack.
• If you put the papers into the machine when the green working light is off, the machine
will be buzzing and stop heating, until the documents have been taken out.
• Before using, please choose the proper thermal cover according to the thickness of
the documents referring to following chart:
NOTE!
• The document should be in good order to avoid bad binding result.
• Make sure the thermal cover cling enough to heating board.
• If you are binding a thick document, you may bind the document several times continu-
ously. The machine can be used for binding max. 3 times.
• Average binding time for different cover sizes refer to chart:
Size of thermo cover (mm): Time for binding in minutes:
1 to 6 1
8 to12 2
15 to 24 3
• Please turn off the machine on time after fi nishing binding. And also the machine will
be powered off automatically after 5 minutes stand by.
Sizes of thermal
cover (mm):
Binding capacity
(80 gr/m²):
Sizes of thermal
cover (mm):
Binding capacity
(80 gr/m²):
1 1 – 8 12 81 – 100
2 9 – 16 15 101 – 130
3 17 – 23 18 131 – 160
4 24 – 33 20 161 – 180
6 34 – 50 22 181 – 200
8 51 – 70 24 201 – 220
10 71 – 80
Bindstream Thermo_T220_06.indd 3Bindstream Thermo_T220_06.indd 3 22.10.2008 22:54:2722.10.2008 22:54:27
To Next Page
Loading...