ELECTRONIC CONTROL PANEL
EN - English Page 10
1. Press the scroll
button repeatedly until the display
shows:
• Press the up
or down
button to activate the
holiday mode by setting the number of full days away
from home, or deactivate the holiday mode (OFF).
Once the control panel is back in service mode, the display
will show:
The holiday mode is automatically cancelled when a
regeneration is manually initiated!
PROGRAMMING INSTRUCTIONS -
BASIC SETTINGS
Before entering the programming mode, make sure that
the appliance is in service mode.
In case no button is pressed in a period of 5 min, the
control panel will automatically return to the service mode;
any changes made will NOT be saved!
1. Press the scroll
button and hold it for 2 sec until the
display shows:
• Press the up
or down
button to set the
language.
2. Press the scroll
button again; the display will show:
• Press the up
or down
button to set the time of
day.
3. Press the scroll
button again; the display will show:
• Press the up
or down
button to set the unit of
measure for water hardness. Make sure it is identical
to the unit of measure of the water hardness test kit
or water analysis report that is used to determine the
hardness of the incoming untreated water!
4. Press the scroll
button again; the display will show:
• Press the up
or down
button to set the hardness
of the incoming untreated water.
5. Press the scroll
button again; the display will show:
• Press the up
or down
button to enable or
disable the buzzer.
6. Press the scroll
button again; the display will show:
• Press the up
or down
button to save the settings
into the NOVRAM® and exit the programming mode.
To Next Page
Loading...