28
INSTALLATION
TELEPHONECORD & HANDSETCORD:
1. connect the handset with the base
2. connect the telephonecord to the backside of the telephone; push
the connector till you hear a click
3. plug the telephone plug into your telephone outlet
WALL MOUNT:
1. drill two holes in the wall with a distance of 10cm and insert two
screws; let the heads of the screws stick out a few millimeters of the
wall
2. remove the handsetholder, rotate it 180° and replace it; this holder
will hold the handset when wall mounted.
3. hang the unit on the wall and fixate the telephone wire by means of
cable-clips
TONE/PULSE DIALING:
The TX-117 is capable to dial telephonenumbers with TONE (DTMF
dialing) or PULSE (rotary dialing). Use the T/P switch on the bottom-
side of the telephone to set the required dial-mode.
To Next Page
Loading...
