USB OPTION INSTALLATION
IN AGRÓNIC 2500
MATERIAL NEEDED:
Internal cable with phone jack to be installed inside Agrónic 2500.
External cable with USB connector to connect the Agrónic 2500 with the PC.
MOUNTING:
1. Disconnect equipment power supply.
2. Remove screws that hold the keyboard: 4 in the box model or 6 in the “built-in” model.
3. Lift the keyboard and disconnect cables from H1 and H3 connectors (relays model) or from H1 and
H2 connectors (latch model) placed in the main board.
4. Hole in box for the connector:
box models: First, base board must be removed. Then, a hole in the right side of the box has
to be performed (look at the image below).
“built-in” models: The hole is already performed and it is placed in the left side of the box.
The plastic lid that covers the hole must be removed, taking care in not damaging the base
board.
5. Install the provided internal cable. Place the cable through the box hole and place the round connec-
tor in the box wall by pushing strongly. Look at the following pictures.
To Next Page
Need help?
General
