***************************************************************************************************************************************************************
WARNING
- If any Special Control Devices are used with this Fixture, Follow the Instructions Carefully to assure full
compliance with N.E.C. requirements. If there are any questions, contact a Qualified Electrical Contractor.
WARNING
- This product contains chemicals known to the State of California to cause cancer, birth defects and /or
other reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
***************************************************************************************************************************************************************
1.
C
WIRE
WHITE SUPPLY
WIRE
BARE, OR GREEN
BLACK SUPPLY
BARE, OR GREEN
FROM SUPPLY
GROUND WIRE
FROM SUPPLY
GROUND WIRE
BARE, OR GREEN
GREEN GROUND
SCREW
FIXTURE GROUND
OR
WIRE
WHITE OR IDENTIFIED
FIXTURE WIRE
PLAIN OR BLACK
FIXTURE WIRE
WIRE NUTS
UL LISTED
A, B, D
WARNING
- the edge of the wall plate must be sealed to the wall with a permanent waterproof material (latex,sillcone,
urethane, etc.) to comply with U.L. requirements.
CAUTION
- All glass is fragile, use care when handling Glass component(s) and or Lamp(s).
D & F
(NOT FURNISHED)
(NON FOURNIE)
(NO INCLUIDA)
ASSEMBLY STEPS:
ASSEMBLAGE ÉTAPES:
MONTAJE PASOS:
SPEC.NO. 93073512
Assembly & Installation Instructions
Read instructions carefully and turn electricity off at main
circuit breaker panel before beginning installation.
CAUTION:
PAGE 1 of 6
09-01-2016
P6341
NOTE:
For more product specifications and information see www.progresslighting.com
• Power source:102 - 145VAC
•
Rated load: 360W max (tungsten)
•
Rated load: 80W max (flourescent)
•
Power frequency: 50 / 60Hz
•
Rotary angle: 360°
•
Water-proof level: IPX5
•
Working humidity: < 93% RH
•
Working temperature: -20° to +65°C (-4° to 149°F)
Turn the knob clockwise for maximum setting and
counter-clockwise for minimum setting.
The knobs have been preset at the factory but may
need to be adjusted to personal preference.
- "
TIME
" controls the length of time the light remains
"on" (approx 2 seconds to 80 minutes).
- "
SENS
" controls the sensitivity to motion (approx
detection angle 180°; range 0m to 20m).
- "
LUX
" controls sensitivity to light. (approx light
sensitivity 10Lux when set to min).
B
C
D
E
F
A
GROUND
(GRN)
LINE (BLK)
120V ONLY
BLK
WHT
RED
GRN
BLK
WHT
GRN
BLK
WHT
COMMON
(WHT)
GROUND
(GRN)
LINE (BLK)
120V ONLY
BLK
WHT
RED
GRN
BLK
WHT
COMMON
(WHT)
2 X
To Next Page
Need help?
General
