ance to a separate earth in compliance with
current regulations, consulting a qualified
electrician.
The Manufacturer declines all responsibility if
the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Di-
rectives.
Removing the shelf holders
Your appliance is equipped with shelf retain-
ers that make it possible to secure the
shelves during transportation.
To remove them proceed as follows:
1. rise the shelf from the back (A)
2. push it in the direction of the arrow until it
is free (B)
3. remove the retainers.
A
B
Door reversibility
The door of the appliance opens to the right.
If you want to open the door to the left, do
these steps before you install the appliance:
1. Loosen and remove the upper pin.
2. Remove the upper spacer.
3. Remove the upper door.
4. Loosen and remove the middle hinge.
5. Remove the lower door.
6. Loosen and remove the lower pin.
7. Remove the lower spacer.
On the opposite side:
1. Remove the hinge cover and install it on
the opposite hinge.
2. Install the lower spacer.
3. Tighten the lower pin.
4. Install the lower door.
5. Tighten the middle hinge.
6. Install the upper door.
7. Install the upper spacer.
8. Tighten the upper pin.
progress 27
To Next Page
Loading...
Need help?
General
