Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Force Cen-
ter.
Technical data
Dimension of the recess
Height 1580 mm
Width 560 mm
Depth 550 mm
Rising Time 20 h
The technical information are situated in the
rating plate on the internal left side of the ap-
pliance and in the energy label.
Installation
Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Positioning
Warning! If you are discarding an old
appliance that has a lock or catch on the
door, you must ensure that it is made
unusable to prevent young children
being trapped inside.
Important! The appliance shall have the
plug accessible after installation.
Install this appliance at a location where the
ambient temperature corresponds to the cli-
mate class indicated on the rating plate of the
appliance:
Climate
class
Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Electrical connection
Before plugging in, ensure that the voltage
and frequency shown on the rating plate cor-
respond to your domestic power supply.
Voltage can vary by ±6% of the rated voltage.
For operation with different voltages, a suit-
ably sized auto-transformer must be used.
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power sup-
ply socket is not earthed, connect the appli-
26 progress
To Next Page
Loading...
Need help?
General
