Project Nursery Sleepy Sloth User Manual

Install Batteries
1. Useaathead
screwdrivertoopen
thebatterydooron
thebackoftheSleepy
Sloth.
2. Insert3AAbatteries
(notincluded).
3. Putthebatterydoor
backinplaceandscrew
itshut.
Position the Sloth
TheSleepySlothcomeswithabuilt-instand,pre-
installedforeasypositioningonatabletoporotherat
surface.YoucanalsomounttheSlothsecurelytoacrib
usingthestrapsontheback.
To mount the Sloth to a crib:
3. PlacetheSlothonthetoprailofthecrib.Wrapthe
strapsaroundthecribrailandfastenthemsothatthe
Slothremainssecurelyinplace.
1. RemovetheSloth’s
standbypullingit
gentlyoffthebottom
oftheSloth.
2. Unfastenthestrapson
thebackoftheSloth.
IMPORTANT: TheSleepy
Slothcomeswithadomecap
youcanusewhenyoudon’t
wanttoprojectonthewallor
ceiling.Ifyoudowanttoprojectontothewallorceiling,
removethecap.
If you’re mounting to a crib:
MakesuretheSloth’sdome
capisremoved.

Project Nursery Sleepy Sloth Specifications

General

Brand	Project Nursery
Model	Sleepy Sloth
Category	Baby Accessories
Language	English

Summary

Install Batteries

Open Battery Compartment

Open the battery door on the back of the Sleepy Sloth using a flathead screwdriver.

Insert Batteries

Insert 3 AA batteries into the compartment, ensuring correct orientation.

Secure Battery Compartment

Put the battery door back in place and screw it shut to secure the batteries.

Position the Sloth

Mount to Crib

Steps for mounting the Sleepy Sloth securely to a crib rail using its straps.

Crib Mounting Tip

Ensure the Sloth's dome cap is removed when mounting it to a crib for optimal projector use.

Everyday Use

Nightlight Control

Control the intensity and turn off the nightlight feature of the Sleepy Sloth.

Soothing Sounds Control

Cycle through sounds, adjust volume, and turn off soothing sounds.

Projector Control

Cycle through projector color options and turn the projector off.

Dome Cap for Projector

Use the dome cap to dim the projector and improve visibility of images.

Using the Timer

Timer Function

Automatically turns off the projector and sounds after a set period (15, 30, or 60 minutes).

Using the Bump Sensor

Bump Sensor Activation

Turn the bump sensor on or off and understand its activation behavior.