4
SAFETY INFORMATION
WARNING
• This product is engineered to meet the EPA WaterSense flow requirement. The flow rate is
governed by the aerator or flow controller. If replacement is ever required, be sure to replace it with
a WaterSense compliant aerator or flow controller to retain the water conserving flow rate of this
product.
• The automatic compensating valve shall be used with shower rated at 1.3 gpm (4.9 L/min) or higher.
• The shower shall be used with automatic compensating valve rated at 1.53 gpm (5.8 L/min) or less.
• The product should be installed by a locally licensed plumber.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product.
Estimated Assembly Time: 40 minutes
Tools Required for Assembly (not included): Adjustable Wrench, Screwdriver, Safety Googles.
Helpful Tools (not included): Supply stops, Supply tubing/ttings, Basin wrench.
• Prior to beginning installation, turn off the cold and hot water lines and turn on the old faucet to
release built-up pressure.
• When installing your new faucet, rst hand-tighten connector nuts. Connections that are too tight will
reduce the integrity of the system.
If you are replacing your plumbing valve, please review the four common plumbing methods
illustrated below: CPVC, PEX, IPS, and Copper. Remove the existing handle and valve trim before
replacing your valve. Please follow all local building and plumbing codes.
To Next Page
Loading...