Projecta HP900 User Manual

9
USING THE PROJECTA HP900/HP1200 JUMPSTARTER
AS A POWER SUPPLY
The jumpstarter utilises a 17Ah AGM battery (HP900) and 22Ah AGM battery (HP1200)
and can be used as a power supply by connecting a cigarette lighter plug into the 12V DC
socket at the front of the jumpstarter. It is recommended to check the battery capacity
before using the jumpstarter as a power supply.
Below is a list of approximate run times for various appliances.
TYPICAL APPLIANCE RUNNING TIMES
Appliance Estimated power
Estimated time* (Hours)
consumption (Watts)
HP900 HP1200
Car phones, fluorescent lights 4 30 38
Radios, depth finders 9 21 27
Fridges (portable compressor style) 14 15 19
Camcorders, portable TVs 15 12 15
Electrical tools, bilge pumps 24 79
Cooler/warmers, spotlights 48 34
Air compressors, car vacuum cleaners 80 1.5 2
*Estimated time is based on a fully charged jumpstarter
IMPORTANT: AUTO-RESET CIRCUIT BREAKER FOR DC OUTPUT
The 12V DC socket is protected with an automatic resetting circuit breaker. When the
output experiences a short circuit or overload, the circuit breaker will trip, cutting off the
power temporarily. After a few seconds, the circuit breaker will automatically reset and
provide power again.
Caution: Maximum total current 10A

Projecta HP900 Specifications

General

Brand	Projecta
Model	HP900
Category	Remote Starter
Language	English