- 88 -
b. How to start body sensor?
The body sensor will be activated automatically after the appliance is turned on. The LED
lights of angles will be flashing by turns.
Long touch button “ ” for approximately 3 seconds to start the body sensor function. The
LED lights of angles will be flashing by turns.
Continuously touch button “ ” to shift angles. The body sensor starts working after 360°.
c. How does the body sensor work?
The fan will work in 360 degree oscillation first after the body sensor started; it will send out
beep sounds when get a signal back. After figuring out the suitable angle, the unit will swing
according to this angle for the following work.
If no signal is detected, the unit will detect again with oscillating 360 degree to find the
signals.
If more people signals appear after the angle already fixed, users should touch the button to
start the sensor again.
d. Detecting distance: Best within 2m from the fan
2) Vertical oscillation: Touch button “ ” to activate vertical oscillation function. Oscillation angle:
approximately 80°. Touch the button again, the vertical oscillation function is deactivated.
6. This appliance is initially set in mode “Normal”. You can also touch button “ ” to switch the mode
between “Normal”, “Natural”, “Sleeping” and “ECO”. The LED indicator changes accordingly. (No LED light
for the “Normal” mode.)
1) Normal: This appliance is initially set in mode “Normal”. Under this mode, the fan is working at low
wind speed. You can also touch button “ ” to set your desired wind speed at “Low → Medium →
High → Low …”.
2) Natural: Touch button “ ” to choose the natural mode. LED light of “ ” will be on. And then
touch button “ ” to choose your desired wind speed as follows: / / .
To Next Page
Loading...
