Operation introduction for control panel
Name of control panel
Operation of control panel
13
2
4
5 6
Power
1
Press once to start and press once more to stop the unit.
Fan
4
Press this button to change the operation fan in order of: LOW→MED→TURBO
→AUTO.
3
" " " "
In "COOL" or "HEAT" mode, press " " once, the temperature will decrease
1°C(°F). Press " " once, the temperature will increase 1°C(°F). The temperature
can be selected from 16°C(61°F) ~ 30°C(86°F)
Timer
5
Press timer button to enter into timer setting mode. Under this mode, press " "
or " " button to adjust the timer setting. Timer setting will increase or decrease
0.5 hour by pressing " " or " " button within 10 hours, while timer setting will
increase or decrease 1 hour by pressing " " or " " button beyond 10 hours.
After timer setting is finished, the unit will display temperature if there’s no
operation for 5s. If timer function is started up, the upper indicator will keep the
display status. Others, it won’t be displayed. Under timer mode, press timer button
again to cancel timer mode.
2
Mode
Press this button to change the operation mode as
below: GPH12AJ:COOL → DRY → FAN→HEAT
GPC12AJ:COOL→ DRY → FAN→ COOL
To Next Page
Loading...
Need help?
General
