Montageanleitung / Installation manual
MBN GmbH, Balthasar-Schaller-Str. 3, 86316 Friedberg - Germany
www.proled.com
• Installation must be made on a heat disposal underground, which is adequate dimensioned, to remove the
heat of the desired Flex Strip. The underground must be free of greas, oil, silicone, dust and dirt. We suggest
Isopropanol for cleaning.
• Installation on uneven, low heat-conductive grounding is not suggested as the life time will be shorted and
make fixing difficult. These include wood, plaster board, wallpaper etc.
• Avoid fixing over profile splice. Because of thermal expanding or shrinking a damage of Flex Strip can happen.
Divide the Flex Strip in this case and use flexible connections, for example wire strap.
Installation steps:
1. Remove the protection foil of the adhesive tape
2. Place the Flex Strip in the profile and stuck it gently. Do not use any sharp or metallic tools.
To Next Page
Loading...