15
INSTRUCTIONS FOR THE INSTALLER
SAFETY ADVICE
Important
This appliance is supplied for use on
NATURAL GAS ONLY and cannot be used
for any other gas without modification.
Conversion for use on other gases must only
be undertaken by a qualified person. For
information for use on other gases contact
your local Comet Service Centre.
The cooker must be installed by a qualified
person in accordance with the gas safety
(Installation and use) (amendment)
Regulations 1990 and the relevant building
/I.E.E. regulations.
Failure to install the appliance correctly
could invalidate any manufacturers warranty
and lead to prosecution under the above
quoted regulations.
In the UK C.O.R.G.I. registered installers are
authorised to undertake the installation and
service work in compliance with the above
regulations. All Comet authorised installers
are C.O.R.G.I. registered.
- Installation of flues and ventilation for
gas appliances of rated input not
exceeding 60 kW (1
st
, 2
n
family
gases) – Part 2 Specification for
installation of ventilation for gas
appliances – BS 5440;
- Gas burning appliances – Part 3
Domestic cooking appliances burning
gas – BS 5386;
- Specification for installation of low
pressure gas pipe work of up to 20mm
(R1) in domestic premises (2
n
family
gas) – BS 6891;
- Pipe threads for tubes and fittings where
pressure-tight joints are made on the
threads (metric dimensions) – BS 21:
1985;
- Flexible hoses, end fittings and sockets
for gas burning appliances – BS 669;
Installation of domestic gas cooking
appliances (1
st
, 2
n
To Next Page
Loading...