1. Unscrew the two screws (6) and remove the top co ver (7).
2. Remove the two screws (1) that hold the upper hinge (5).
3. Remove the upper hinge.
4. Lift the door off the lower hinge pin.
Place i t on a padded surface to prevent it from being scratched.
5. Remove the foot (3) and the t wo screws (8) that hold the lower hinge.
6. Remove the lower hinge (2) with hinge pin (9).
7. Unscrew the left front foot (4) and transfer it the right side.
8. Unscrew the hinge pin (9) and re-fit it to the other s ide of the lower hinge (reversed).
9. Screw the lower hinge
onto the left side of the lower frame with two screws (8) and the
foot (3).
10. Position the door in place making sure the
door seats ont o the lower hinge.
11. Align the door in the closed position to secure the upper hinge in the top frame o n the
left side with the screws (1).
Make sure all the screws are tightened.
12. Re-fit the top cover b y tightening t he screws (6).
Noise
Noise
Noise
Noise from
from
from
from your
your
your
your appliance
appliance
appliance
appliance
You
may notice some rather unusual noises. The noises are caused by circulation of
refrigerant in the cooling system. It has become more pronounced since the introduction of
CFC free gases. This is not a fault and will not affect the performance of your fridge.
Prolonged
Prolonged
Prolonged
Prolonged off
off
off
off periods
periods
periods
periods
If the appliance is not in use for a long period of time, proceed as follows:
Disconnect from the mains supply.
Clean and dry the inside (see ‘Cleaning and maintenance’).
Leave the door open to prevent any unpleasant smells from building up while the
appli
ance is not in use.
Reversing
Reversing
Reversing
Reversing the
the
the
the door
door
door
door
Before
Before
Before
Before After
After
After
After
Downloaded from www.vandenborre.be
To Next Page
Loading...
Need help?
General
