Why won't my Proline PFL 126 W-F start?
Your Proline Washer might not start due to several reasons: * The door may not be properly closed, so ensure that it is securely shut. * There could be a poor connection to the power supply; check the connection. * A power failure might have occurred; verify the power supply. * The machine may not be switched on; switch the machine on.
What to do if my Proline Washer vibrates too much?
Excessive vibration or noise in your Proline Washer can occur due to: 1. Transit bolts not removed: Ensure all transit bolts are removed. 2. Uneven surface: Place the washing machine on an even and level surface. 3. Overload: Reduce the amount of laundry in the drum if it exceeds 5kg (for PFL 105) or 6 kg (for PFL 126).
How to fix a Proline PFL 126 W-F Washer that won't drain or spin?
If your Proline Washer isn't draining or spinning, consider these possible causes: * The drain hose might be blocked; unblock it. * The filter could be locked; unblock the filter. * The drain hose end may be higher than 100 cm above the floor; ensure it is lower. * There may be an unbalance of the laundry; add clothes or run a spinning programme again.
What to do if detergent remains in the drawer of my Proline PFL 126 W-F Washer after washing?
If detergent remains in the detergent drawer of your Proline Washer after the programme, it may be because: * The detergent is not a low suds type; check if the detergent is appropriate. * You are using too much detergent; reduce the amount in the drawer.
Key safety measures to prevent hazards and ensure proper appliance use.
Removing transit bolts and packaging before using the appliance.
Advice on placing the appliance on a flat floor with adequate air circulation.
Adjusting appliance feet for stability and to prevent vibration.
Connecting the inlet hose to a cold water supply tap.
Step-by-step guide to loading, detergent, and starting a wash cycle.
Possible causes and solutions for the machine failing to start.
Troubleshooting steps for issues with draining and spinning.
Key safety measures to prevent hazards and ensure proper appliance use.
Removing transit bolts and packaging before using the appliance.
Advice on placing the appliance on a flat floor with adequate air circulation.
Adjusting appliance feet for stability and to prevent vibration.
Connecting the inlet hose to a cold water supply tap.
Step-by-step guide to loading, detergent, and starting a wash cycle.
Possible causes and solutions for the machine failing to start.
Troubleshooting steps for issues with draining and spinning.
To Next Page
General
