7.Select the anti-crease additional function when needed.
GB
NOTE: The additional function which can be selected depends
on the programme you have selected.
Anti-crease:
.
This function prevents creases from forming in the clothes.
Press to select this function. The indicator light above the button
will illuminate indicating this function is activated. If a drying
programme is finished, the dryer will continue to rotate the laundry
at intervals for approximately 2 hours.
To deactivate the function, press again and its indicator light will
go out.
8.Press
.
During the drying cycle, the status indicator light will flash to
indicate current cycle status.
9.After the cycle is finished, the display will show “—”.
If the buzzer function is activated, you will hear beeps when the
drying cycle is finished.
The final part of a drying cycle occurs without heat (cool down
cycle) to ensure that the laundry remain at a temperature which
will prevent the laundry from being damaged.
Anti-crease: If the laundry is not removed at the end of the drying
cycle after approximately 5 minutes, an automatic anti-crease cycle
will operate at intervals. (if you choose anti-crease additional
function this time can be extended up to approximately 2 hours).
.
.
.
36
Press any one of the buttons , , and to make the anti-crease
indicator light ( ) flash. When you press the indicator light
above this button will illuminate to indicate the signal function is
activated. After the anti-crease indicator light flashes for a while it will
go out and the display will show “—” again.
Downloaded from www.vandenborre.be
To Next Page
Loading...
