Proline PTL6100 - Positioning; Installation Location Requirements; Levelling the Appliance

86
Positioning
Install the appliance on a at hard oor.
Make sure that air circulation around the appliance is
not impeded by carpets, rugs, etc.
Allow at least 2 cm of clearance at each side of the
appliance.
Make sure that the appliance does not stand onto the
power cord.
Installation location requirements
Before installing the appliance, the location characterised as follows shall be
selected:
- Rigid, dry, and level surface
- Avoid direct sunlight
- Sucient ventilation
- Room temperature is above 0°C.
- Keep far away from heat resources such as coal or
gas burning appliances.
The ambient temperature of the washer should be 5-40°C. If used under 0°C, the
inlet valve and draining system may be damaged. If the machine is installed under
freezing conditions, it should be transferred to normal ambient temperature to
ensure the water supply hose and drain hose can unfreeze before use.
Levelling the appliance
Levelling the washing machine properly prevents excessive noise and vibration.
Install the appliance on a solid and level oor surface.
If the oor is uneven, turn the adjustable feet as required.
• Never put cartons, wooden blocks or similar materials under the feet.
w
w
W > 20mm