1.Safety and EMC instructions
Please read carefully the following user manual and the safety
instructions before installing the unit or using the unit!
1.1 Installation
★
Condensation may occur if the UPS is moved directly from a cold to a warm
environment. The UPS must be absolutely dry before being installed. Please allow
an acclimatization time of at least two hours.
★
Do not install the UPS near water or in damp environment.
★
Do not install the UPS where it would be exposed to direct sunlight or near heat.
★
Do not block ventilation openings in the UPS’s housing.
★
Place cables in such a way that no one can step on or trip over them.
For UPS T1000/2000/3000
★
Socket-outlets and socket of batteries are earthed by the input power cord, please
insert the power cord into mains socket before using of UPS.
★
Connect the UPS only to an earthed shockproof socket outlet.
★
The building wiring socket outlet (shockproof socket outlet) must be easily accessible
to close to the UPS.
★
This is operator installable .
1.2 Operation
★
Do not disconnect the earth conductor cable on the UPS or the building wiring
socket (grounded shockproof socket) during operation as this would remove the
ground to the UPS and of all connected loads.
★
The UPS output socket or output terminal block may be electrically lived even if the
UPS system is not connected to the building wiring terminal.
★
In order to fully disconnect the UPS, first press the Standby button, then disconnect
the mains lead.
★
Ensure that no liquid or other foreign objects can enter the UPS.
★
The UPS can be operated by any individuals with no previous experience.
To Next Page
Loading...
Need help?
General
