What to do if Proline I2000 UPS displays code 3 and beeps?
If your Proline UPS displays the mode code '3' and you hear an alarm sounding with one beep every four seconds, it means the main power supply has failed, or the input power and/or frequency are out of tolerance. The system is automatically switching to battery mode. Check the input power source. If the problem continues, contact your dealer.
What to do if my Proline UPS is overloaded?
If your Proline UPS is overloaded, check the connected loads and remove any non-critical ones. Also, verify if any of the connected devices have failed.
Why does my Proline UPS show line voltage high?
If your Proline UPS indicates a line voltage high (OVCD action), it means the input power voltage is too high. The system will automatically switch to battery mode and will switch back to line mode automatically once the mains power returns to normal.
How to fix over temperature fault in Proline I2000 UPS?
If your Proline UPS is experiencing an over-temperature fault, check the ventilation around the UPS and ensure that the ambient temperature and ventilation are adequate.
Why is the Proline I2000 UPS emergency supply period so short?
If the emergency supply period of your Proline UPS is shorter than expected, it could be due to batteries not being fully charged or defective batteries. Charge the batteries for at least 5-8 hours, then check their capacity. If the problem persists, consult your dealer.
What to do if Proline I2000 fan fails?
If your Proline UPS fan fails, check if the fan is running, as the fan may be abnormal.
How to fix 'Battery Open' error on Proline UPS?
If your Proline UPS shows 'Battery Open', it means the battery pack is not connected correctly. Perform a battery test to confirm. Check that the battery bank is properly connected to the UPS and that the battery breaker is turned on.
What causes battery over voltage in Proline I2000 UPS?
If your Proline UPS indicates a 'Battery Over Voltage' issue, it means the battery is being overcharged. The UPS should automatically switch to battery mode. Once the battery voltage normalizes and the mains power is stable, the UPS will automatically switch back to line mode.
Why Proline I2000 UPS has no indication even connected to power?
If you have no indication or warning tone from your Proline UPS, even when it's connected to the mains power supply, it could be due to no input voltage. Check the building wiring socket outlet and the input cable.
What causes DC-DC temperature high in Proline I2000 UPS?
If your Proline UPS reports a 'DC-DC temperature high' or 'Inverter temperature high' error, it indicates that the internal temperature of the UPS is too high. Check the ventilation around the UPS and the ambient temperature.
Guidance on installing the UPS, including acclimatization and placement.
Details UPS input connection requirements and recommended breakers.
Details the Line mode display and conditions.
Mentions no user-serviceable parts and when to contact the dealer for battery replacement.
Details battery replacement by qualified personnel, including shutdown and testing.
General| Capacity | 2000VA / 1200W |
|---|---|
| Waveform | Simulated Sine Wave |
| Operating Temperature | 0°C to 40°C |
| Weight | 12.5 kg |
| Output Voltage | 230V AC |
| Frequency | 50/60Hz |
| Transfer Time | Typical 4-8ms |
| Battery Type | Sealed Lead-Acid (SLA) |
| Battery Recharge Time | 4-6 hours |
| Protection | Overload, and overcharge protection |
| Communication Interface | USB |
| Humidity | 0-90% RH non-condensing |
| Storage Temperature | -15°C to 45°C |
To Next Page