Hardware Installation3
Web-based Configuration4
Power On the device
Press and hold the power button for 5-10 seconds until power is turned on.
1. Connecting to the device.
Use 4G network
The management parameters of this machine have been preset according
to the requirements.It will automatically connect to the Internet.
Note:
You can log in to the web administration page and enable or disable automatic
connections.
EN3
A. With Wi-Fi connection.
- Use your normal Wi-Fi application on the client to search for the
available wireless network
- Select the SSID of your device (default SSID Prolink_xxxx) to connect
- Default password is prolink12345
B. With USB connection.
- Connect the device with USB cable into Computer USB port
- NDIS driver will be installed automatically
Note:
1. Use only chargers that are compatible with this unit and supplied by the specified
manufacturer. Using an incompatible charger or a charger from an unknown
manufacturer may cause MiFi failure, malfunction, or even fire.
2. Recharge battery: connect the provided USB cable to DL-7202's USB Type-C port.
Charge the battery
If the unit has not been used for a long time or the battery is completely
depleted, the unit may not power up immediately after the charger is
plugged in. Please charge the battery for a period of time before trying
to turn it on.
To Next Page
Loading...
