Overview
2
Installation
3
EN2
To reset the bulb to factory
default
To switch between Wi-Fi Mode
and AP Mode configurations
Power O – Power On the bulb
for three (3) consecutive times
Power O – Power On the bulb
for three (3) consecutive times
Activity Action Required
A. Preparation
1. Place the Smart Bulb and Phone within three feet of
the router
Notes:
• Make sure the phone is connected to the router through 2.4GHz
Wireless network.
• Smart Bulb is operating only at 2.4GHz Wireless N standard.
To Next Page
Loading...
Need help?
General