Overview
2
Installation
3
EN2
To reset the bulb to factory
default
To switch between Auto Mode/
EZ Mode and AP Mode
configurations
Power O – Power On the bulb
for three (3) consecutive times
Power O – Power On the bulb
for three (3) consecutive times
Activity Action Required
A. Preparation
1. Place the Smart Bulb and Phone within three feet of
the router
Notes:
• Make sure the phone is connected to the router through a
2.4GHz wireless network.
• Smart Bulb is operating only at 2.4GHz Wireless N Standard
(Support WPA OR WPA2 only).
English
To Next Page
Loading...