To Next PageTo Next PageWhat to do if PROMA REHA VERTICO Medical Equipment emits light, but does not respond to the control?
If your PROMA REHA Medical Equipment bed is not working, but the light is on and it's not responding to the controls, try restarting the bed. You can reset the software and switch off the bed using the button on the control box. After resetting, always check the bed function.
What to do if PROMA REHA Medical Equipment bed is non-functional – does not emit light, does not respond to the control?
If your PROMA REHA Medical Equipment bed isn't working—it doesn't emit light and doesn't respond to the control—first, ensure it's properly connected to the electricity network. If not, plug the power supply cable in. Then, disconnect the power supply cable and inspect it for any damage. If damaged, stop using the bed and contact the service center. Also, verify that the electrical network the bed is connected to is working. Check if the green diode on the control unit is lit, indicating power supply. If it's off, disconnect the bed and contact the service center. Finally, disconnect the bed from the power and check the cables of the control elements for damage; if damaged, discontinue use and contact the service center.
How to fix the flashing buttons on the PROMA REHA VERTICO Medical Equipment patient hand controller?
If the buttons on your PROMA REHA Medical Equipment patient hand controller are flashing, remove the universal plastic key from the controller.
Instructions for powering down the bed using the patient controller for transfer or storage.
Procedure to power on the bed using the power supply or reset button.
General guidelines for operating electrical controls, including patient controller and nurse panel.
Detailed guide on using the patient hand controller for bed positioning.
Information on backup batteries for emergency operation and their status indicators.
Explanation of the clamp used for electrical potential balancing and its connection.
Details on the power supply cable holder and its use during transport.
Operation and positions of the central brake system for securing the bed.
Steps for adjusting the calf part of the bed to different pre-set positions.
Procedure for the mechanical quick lowering of the back part in emergency situations.
Instructions for tilting, removing, and re-attaching the tiltable siderails.
Steps for removing and inserting the bed's removable headboard.
Description of the bearing area material and safety precautions for the area under it.
Information on the impact wheels located at the bed corners and their protection.
Use and restrictions for universal accessory holders on the bed.
Details on the "Eurobars" accessory holders for hanging items.
Instructions for properly fixing the patient using safety belts before verticalization.
Installation and usage instructions for the trapeze bar with a small bar accessory.
Guide to using the infusion stand for hanging bottles and medical bags.
Troubleshooting steps when patient controller buttons are flashing, indicating lock mode.
Steps to troubleshoot a bed that shows no power indication and does not respond to controls.
Procedure for restarting and troubleshooting a bed that emits light but is unresponsive to controls.
Interpreting and resolving error messages indicated by flashing LEDs on the patient controller.
Explanation of the information provided on the bed's manufacturing label.
General| Brand | PROMA REHA |
|---|---|
| Model | VERTICO |
| Category | Medical Equipment |
| Language | English |
