2016 & 2017 PROMASTER REAR SPEAKER
INSTALLATION
10. Exit the Engineering Mode menu by pressing the RADIO and MEDIA
buttons then, shortly after that, while still holding RADIO and MEDIA
buttons, press the BROWSE/ENTER button. Hold all for approximately 5
seconds. The normal Radio or SXM tuning screen will appear.
11. Switch off the radio, turn the ignition key off and remove it from the ignition.
Disconnect any service tools from the diagnostic connector and close all doors.
Wait 5 minutes to allow all vehicle electronics to power down internally.
12. Turn the ignition key on and turn on the radio. Rear speakers should now be
enabled. Verify by accessing the balance/fade screen. If the rear speakers have
been enabled, the following screen will appear and the rear speakers will be
active.
Page 13 of 14
To Next Page
Loading...