2016 & 2017 PROMASTER REAR SPEAKER
INSTALLATION
NOTE: To eliminate the setting of fault codes, rear speakers should
only be enabled AFTER the rear speakers have been properly
connected to the vehicle electrical system.
NOTE: Do not attempt to make any other changes to radio
configurations while in the Engineering Mode menu.
After the speakers are properly connected, perform the steps outlined on the following
pages to enable the speakers. Once the steps are correctly performed, the speaker fade
control will now be visible in the audio control menu of the radio and the rear speakers
will function.
1. Simultaneously press and hold the RADIO, MEDIA and BROWSE/ENTER
buttons.
Page 2 of 14
To Next Page
Loading...