!
Version 2.0
Included Parts
• Studio shell fabric / case x 1
• Diffusion panel x 1
• LED light strips x 2
• AC power supply x 1
• Vinyl backgrounds x 4
!
Assembly
!
1) Lay!the!case!on!a!flat!surface!with!the![pro]master!logo!facing!up.!
2) Remove!any!items!which!may!be!in!the!pouch!on!the!front!of!the!case!and!set!these!
items!aside!for!now.!
3) Open!the!case!and!fold!out!each!of!the!panels!flat.!!
4) Bring!the!panels!together,!edge-to-edge,!one!at!a!time!pressing!their!sides!together!for!
a!firm!attachment.!Build!a!cube!by!doing!this.!
5) Set!the!assembled!cube!out!so!the!panel!with!the![pro]master!logo!becomes!the!front.!
6) Choose!one!of!the!4!backgrounds.!
7) Open!the!top!flap!of!the!cube.!
8) Attach!the!background!to!the!back,!inside!of!the!cube!using!the!hook!and!loop!
fasteners.!
9) Roll!the!background!down!to!the!back,!inside!portion!of!the!cube!and!across!the!
bottom.!Then!tuck!the!end!of!the!background!into!the!seam!at!the!bottom,!front!edge!
of!the!cube!to!keep!it!in!place!
10) Close!the!top!panel!of!the!cube.!Your!background!is!installed!and!ready.!
11) Now!open!the!front!panel!of!the!cube.!
12) Locate!the!two!LED!light!strips!and!insert!them!into!the!inside,!top!panel!of!the!cube!by!
siding!them!into!the!elastic!bands.!Be!sure!the!LED!lights!are!facing!down!into!the!cube!
and!the!power!cords!on!the!LED!light!strips!are!oriented!towards!the!back!of!the!cube.!
13) Route!the!two!power!cables!through!the!small!hatch!near!the!back!of!the!top!panel.!
14) Locate!the!white!diffusion!panel.!Connect!its!4!corners!to!the!inside!of!the!cube!by!
joining!the!hook!and!loop!fasteners!on!the!diffuser!with!the!white!hook!and!loop!tabs!
inside!the!cube!in!each!of!its!corners.!Be!sure!the!fabric!hatch!in!the!diffuser!is!oriented!!
downward!so!it!can!easily!be!opened!and!closed.!!
To Next Page
Need help?
General
