a.
Operating a TV
When operating a TV monitor or TV/DVD combo, please note that picture tubes have a degaussing coil, which uses a
high initial surge of power to light up the screen from a “cold start”. If the TV does not start up on the first try, switch the
TV on every 2-3 seconds until the screen comes on. Some screens may take 2-5 tries before starting.
b.
Operating with an extension cord
We recommend that you use an extension cord no longer than 16AWG 50ft. between the AC output and AC appliance. A
longer cord may result in reduced output.
USB PORT
NOTE: Prior to connecting the accessory, make sure that the USB port On/Off power switch is in the OFF position. Accessory
Connection (IPad, IPhone…, etc.)
1.
Connect the USB interface cable (provided with the accessory) into the accessory and the Portable Power Station USB
port.
2.
Press the USB Port On/Off switch of the unit to the ON position. Turn on the accessory for operation.
3.
Press USB Port switch to OFF position when not in use.
NOTE: To avoid draining of the battery while using the USB port, kindly check time to time the battery voltage. And do not let it
reach to <11V (below 11V). This will permanently damage the battery.
TWO 12V DC PORT
The Powers tation is equipped with two outlet socket and can be used to operate most 12- v o l t auto accessories and
appliances (11 AMP maximum) equipped with a cigarette lighter plug. Simply plug in appliance. NOTE: Socket is live so
appliance will be instantaneously powered. Length of time appliance will operate depends on the condition of battery and
current draw of appliance. Periodically check battery voltage status “VDC” during operation and discontinue use immediately if
battery condition falls to 11V.
Recharge unit as soon as possible and before further use.
12V DC PORT is protected by an internal circuit breaker to prevent damage to unit in case appliance has a short circuit or
exceeds 11 AMPS. If circuit breaker is tripped, disconnect appliance and have it checked. Circuit breaker will automatically
reset once it cools down (approx. 15-20 minutes). DO NOT PLUG A CIGARETTE LIGHTER INTO THE OUTLET OF THE
POWER STATION.
FRONT LED WORKLIGHT
1.
Simply switch ON the LED worklight by pressing the LED button.
2.
To turn OFF the LED worklight, press again the by LED button.
NOTE: To avoid draining of the battery while using the LED Light, kindly check time to time the battery voltage. And do not let it
reach to <11V (below 11V). This will permanently damage the battery.
To Next Page
Loading...