What to do if Pronteau Boiler has reduced water flow?
If you experience reduced water flow with your Pronteau Boiler, make sure the hoses are not kinked or damaged; replace or re-route them if necessary. Also, check if the unit is excessively scaled up and descale it. Descale the drain valve (E3) by removing it and soaking it in descaling solution.
Why does my Pronteau Boiler tap eject water when heating?
If your Pronteau Boiler tap ejects water during heating or is constantly boiling, the thermostat might be set too high. Turn it anti-clockwise to reduce the set temperature and re-calibrate it. Allow time for the drain valve to work.
How to fix Pronteau Boiler water not hot enough?
If the water from your Pronteau Boiler is not hot enough, the thermostat might be set too low. Turn it clockwise slightly to increase the set temperature. You may need to re-calibrate it.
What to do if boiled water flow is reduced in Pronteau Boiler?
If the boiled water flow from your Pronteau Boiler is reduced, check that the tubes are not kinked. The boiler may also need descaling.
What to do if Pronteau Boiler unit is not heating but light is on?
If your Pronteau Boiler unit is not heating but the light is on all the time, check the circuit through the element (50.4-58.7 Ohms) and replace it if necessary. Also, check continuity through the run dry thermostat and replace if needed. Finally, check the thermal fuse and replace it if necessary.
What to do if Pronteau Boiler unit is not heating and no light is on?
If your Pronteau Boiler unit is not heating and there is no light on, check the fuse in the plug. Also, check the circuit through the thermostat and replace it if necessary.
How to fix Pronteau Boiler light not on and water cold?
If the light is not on and the water is cold in your Pronteau Boiler, check that the electrical supply is connected and switched on, and that the plug fuse is not blown.
Why is there no water flow when I turn on my Pronteau Boiler tap?
If there is no water flow when the tap is operated on your Pronteau Boiler, check that the water supply is on. Note that there can be a short delay depending on how long the unit has been left unattended.
Covers appliance safety, daily use, modifications, fire precautions, and general operation.
Explains how to operate the tap for different water types and general use.
Details the process and precautions for descaling the boiler for optimal performance.
Guides on how to drain the system and replace the filter cartridge.
Provides solutions for common issues and guidance on professional service.
Advice on cleaning the tap mixer to preserve its appearance and avoid warranty issues.
Outlines the warranty coverage and limitations for the PROBOIL boiler system.
Details the warranty coverage and limitations for the Abode mixer tap.
Technical data, parts list, and step-by-step instructions for installing the mixer tap.
Covers pack contents, tools required, and the sequence for fitting the boiler unit.
Detailed instructions for fitting the drain valve and connecting all necessary water tubes.
Guides on calibrating the boiler temperature and understanding how the system works.
Illustrates overall system connections and provides key technical specifications.
Lists available spare parts for the PROBOIL system with their corresponding part numbers.
General| Type | Electric |
|---|---|
| Capacity | 2 liters |
| Finish | Stainless Steel |
| Voltage | 220-240V |
| Material | Stainless Steel |
| Power | 1500W |
| Frequency | 50Hz |
To Next Page
