7
IN THE PACKAGING
OPERATING
USAGE
MAINTENANCE
The cable reel must be installed in premises conforming to current regulation and standards covering
electrical systems and work environments.
Secure the cable reel to the wall and the ceiling to the installation diagrams. Using screws anchors or
suitable screws which must be fitted in the holes in the brackets.
Adjust the cable stopper to the suitable position when required.
•
•
•
Check reel for correct operation by slowly pulling out the hose. A “clicking” noise will be heard every half
revolution of the drum.
To latch the reel, pull out the cable and allow it to retract after hearing the first second or third “click”.
To unlatch, slowly pull out the hose until the “clicking” noise stops, and then let the cable retract until the
cable stopper rests against the cable guide.
Make sure the cable is in proper working order and that the insulation is not cut or worn as this could
represent a hazard and jeopardize operation. Clean the cable with a cloth dipped in warm water to remove
dirt or deposits and ensure correct rewinding. Do not use detergents or solvents, which could prove
incompatible with cable-winder materials. In the event of having to perform maintenance on the
electrical, mechanical parts or replace the cable, contact an authorized after-sale service centre.
Dismantling of the unit by unskilled personal could prove hazardous; the risk involved mainly concern the
preloaded springs.
Note: To avoid damage to the reel, always hold on to the cable while it is rewinding.
1)
2)
3)
IN THE PACKAGING, OPERATING, USAGE
To Next Page
Loading...