Tips On Use
Steaming clothing
Garments can either be steamed on a hanger on a rail or hung from the hook on the pole
assembly. Ensure that the pole hook is over the steamer when hanging clothing on it; this
maintains the stability of the machine. Run nozzle over the fabric keeping row of holes
horizontal at all times. Nozzle should not be tilted as this may result in water condensation
being emitted after a period of use. Provide tension and control to fabric with the other hand.
Full garments such as dresses and skirts can be steamed from the inside by touching nozzle
onto material and steaming outwards, this will reduce the possibility of adding creases, and
opens up gathers. The back of the nozzle can be used as a low temperature iron to confirm
creases and to shape collars. Never steam clothes whilst they are being worn by a person
.
Curtains & Soft Furnishings
Steam curtains from the face side, if interlined it may be necessary to steam lining as well.
Start by steaming headings, then work downwards. If using optional Drapery Kit, it will be
necessary to change to standard Drapers hose when working at heights of less than 2 metres,
otherwise a large amount of condensation will build up in the hose. When steaming,
periodically lift hose so excess condensation can run back into the boiler. Ideal for use on bed
valances, chair covers, drapes and removing pressure marks on carpets.
Do not use on moiré silk, seersucker, silk taffeta, artificial and natural furs or nap side of
leather. If in doubt, test on a small inconspicuous area or steam from back of fabric. No
contact should be made with man made pile fabrics - keep nozzle at least 10 cm away from
face or reverse, allowing steam to penetrate, and brush the pile. Cotton velvet can be steamed
by lightly running the nozzle over the pile. In the event of a condensation spot on fabric, rub
the back of the nozzle over the area; it should dry without leaving a water mark.
Regularly rinse your steamer (see instruction in Care of Your Steamer). Failure to do so will
cause a build up of water impurity sediment in the boiler. Sediment will displace water which
can cause hot water to eject from the nozzle. Also the performance of the heating element
can be effected which may invalidate your guarantee. If the steamer is used in a location with
hard water, periodic use of a Propress descaling product is recommended.
Model No.: PROPRESS PRO290
2 Litre 50/60Hz
~ 230 Volt 1500W THIS APPLIANCE MUST BE EARTHED
Waste Electrical and Electronic Equipment (WEEE) Directive in the European Union.
This label indicates that this product should not be disposed of with household waste.
It should be deposited at an appropriate facility to enable recovery and recycling
.
To Next Page
Loading...
