25
There are 1 line input. on the back panel
LINE IN Mode
1. USB port:Use it to insert the USB memory storage device with MP3 files.
2. SD port:Use it to insert the SD card with MP3 files.
3. Remote receiver.
4. Input mode:Select an input mode,BLUE/FM/MP3 player.
5. Press once to jump previous song or FM channel.
Press and hold to decrease the volume level
.
6. Press once to jump next song or FM channel.
Press and hold to increase the volume level.
7. It is repeat button. We provide 4 modes Repeat all/ Repeat one/Random/
Folder Repeat all
.
8. Press once to play or pause a song(MP3 mode)
Press and hold on to enter folder mode, the screen will show " FOLD".
then press or to choose your favorable music folder.
Press once to search radio stations and they can be saved automatically(FM mode).
9. Mic 1 level control:Use this control to set the volume level of Mic 1 IN signal.
10. Mic 2 level control:Use this control to set the volume level of MIC 2 IN signal.
11. MP3 level control:Use this control to set the volume level of Mp3 signal.
12. Equalizer:designed for 12db cut or boost.
13. Mic Input:1/4” connector for a unbalanced Microphone.
14. MP3/LINE IN Switch
volume control.
15. Overload indicator:If the red LED ON constantly,low down the general
16. 115V-230V selector.
17. AC power:Use it to connect the AC power cord.
18. LED light switch.Note:The bulit-in LED lights only work with music rhythm
at certain volumn level.P.S.If the lights don’t work,please try turning up the volumn.
19. Speaker out:It is SPEAKON jack,use it to connect another passive speaker.
20. ON/Off power switch.
21. Line Output: Allow you to connect another active or mixer console through
RCA jack speaker.
22.Line Input: Allow you to connect an external audio device through RCA jack.
1.Turn on the power.
2.Turn the MP3 button to the minimal level.
3.Check the MP3/Line selector. If it is in "in" position,press it out.
4.Connect the music source through RCA jack
5.Turn the MP3 button to a suitable level respectively.
1
2
MP3
3 5
MP3
4
The bulit-in LED lights only work with music rhythm at certain volumn level.
P.S.If the lights don’t work,please try turning up the volumn.
You can use the LINE IN function when you wish to link up an additional
stereo signal source without the use of a mixer console, such as CD players,
DVD music plays,MP3 players.
Note:Remember to turn up the volume of the connect device to a
suitable level for a good sound effect.
LED Light Note
To Previous Page
Loading...