3. Trim excess body hair from the area with scissors (do not shave).
4. Optionally, apply skin prep to the area to form a protective barrier on your skin. Apply, let dry, and apply electrode as directed.
This will both reduce the chance of skin irritation and extend the life of your electrodes.
5. When removing electrodes, always remove by pulling in the direction of hair growth.
6. It may be helpful to apply skin lotion on the electrode placement area when not wearing electrodes.
Connecting the Cable to The Device
Connecting the lead wire to the electrodes before applying to the Skin.
Inserting/Changing the Batteries
1. Open the battery compartment at the back of the device by pushing the battery cover labelled “Open” downward (this area
features raised marks for easy identification).
2. Insert 3 AAA (1.5 V) batteries in the battery compartment; make sure to match up the symbols (+/–).
3. Close the battery cover by carefully placing the stud into the slot in the rear area and sliding it upward, applying slight pressure.
4. Follow the same procedure when replacing the battery at a later date.
Note:
For important precautions regarding the batteries, please be informed:
Always use only 3×1.5V(AAA) batteries.
Keep away from children.
Do not recharge.
Do not short-circuit.
Do not throw into a fire.
Please recycle. Do not dispose of old batteries with your household waste; dispose of them safely at your recycling centre or
business where the batteries were purchased.
Placement of the Electrode Pads for TENS
(Treatment of Pain)
Note:
You may need help placing the Electrode Pads onto hard to reach areas (lower & upper back)
To Next Page
