Using Your TV and Remote
With a Laserdisc Player: Programming and Basic Operation
Refer to your Laserdisc Player owner's manual to hook up your Laserdisc Player.
The remote may need to be programmed for your laserdisc player. This
remote may not operate all models of the brands that are shown below. Use
the codes below or on the sheet packed in with your remote.
Program the remote for
your Laserdisc Player
Basic Operation
A. Point the remote at the laserdisc
player and hold LD.
B. Enter tlhe code for your brand
from the code list below.
C. Release LD.
D. Press POWER. If nothing
happens, try pressing LD and
then POWER.
A. Tune TV to channel 00, 03, or 04.
B. Point tile remote at the laserdisc
player and press LD.
C. Press POWER to turn it on.
D. Use the buttons on the remote
that relate to laserdisc player
functions. Not all buttons high-
lighted may work with your
laserdisc player.
E. Press POWER to turn it off.
Laserdisc Player Codes
/
Pioneer ........................33
ProScan .......................33 _
14
To Next Page
Loading...