34
12
UMBRELLA LIGHT INSTALLATION
(UMBRELLA LIGHT IS NOT INCLUDED)
ASSEMBLING THE BASE
Caution:
Remove the tube carefully (step 4) to avoid sand getting into the center of the base shell.
Fill the base completely with 90 kg / 200 lb sand, then add water to wet down the sand.
Only use the base provided with this umbrella. Other bases may not fit with this
umbrella and could cause a safety issue. Make certain the base is securely
placed on flat surface before inserting the umbrella.
B
N
5
F
L
6
7 8
Connect the rotation part with tube.
Connect the rotation part with tube.
411
To Next Page
