NOTE
a) The Finial (B) contains two lithium batteries (2 x 2200mAh). To charge
the batteries using the solar panel, press the switch to the off position
during daylight. Charging time depends on the amount of sunlight;
however, at least 8 hours is recommended.
b) To charge batteries with the AC adapter, remove the cap on the charging
port, connect with the end of AC adapter and then screw together.
Ch
arging time is approximately 5~6 hours.
c) The AC adapter could be used both indoor and outdoor, while the outdoor
plug needs to be covered to prevent water entering when it is in use.
d) This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, (2) this device must accept any interference received,
i
ncluding interference that may cau
se undesired operation.
a) The Finial (B) contains two lithium batteries (2 x 2200mAh). To charge
the batteries using the solar panel, press the switch to the off position
during daylight. Charging time depends on the amount of sunlight;
however, at least 8 hours is recommended.
b) To charge batteries with the AC adapter, remove the cap on the charging
port, connect with the end of AC adapter and then screw together.
Charging ti
me is approximately 5~6 hours.
c) The AC adapter could be used both indoor and outdoor, while the outdoor
plug needs to be covered to prevent water entering when it is in use.
d) This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, (2) this device must accept any interference received,
including in
terference that may cause
undesired operation.
4 5
TO CLOSE THE UMBRELLA
Hold the rope firmly and remove the pin, then release the rope
slowly until the umbrella is fully closed. Use tie straps to secure
umbrella canopy.
Attention: If the umbrella is stored in a box when not in use, the solar
panel and finial must be removed prior to putting the umbrella in the box
to avoid damage.
TO USE LED LIGHTS
For everyday normal use, turn the light switch on at night when
y
1. High-low feature is available for LED lights. Press switch button
once to get high lighting. Press a second time to get lower lighting.
Press a third time to turn off the lights.
2. When solar energy is insufficient, you can use the AC adapter to
charge the battery. Charge level can be seen on power indicator.
3. USB port could be used to charging your phone or other devices
via a USB cable (USB cable not included).
o
1. Charging port
2. Switch button
Charging here
AC Adapter
3. Power display switch
Power indicator
4. USB port
u want to use the solar light and turn off the switch after use.
Power display switch
Power indicator
Switch button
USB port
Charging port
To Next Page
Loading...
