Prospera PL028 - Massage and Water Jet Functions; Power Off and Water Drainage

7
Two-Digit
display
•
When the power is turned on, the LED screen displays its
current water temperature inside water container and its
default working time (30 minutes).
8
Red Light
Press Red Light button to turn on red light for fun:
•
Press Red Light button once: red light is on.
•
Press Red Light button twice: red light is off.
9
Massage
•
Press Massage button to turn On/Off rolling massage
function.
•
Default time for rolling massage is 15 minutes.
•
Massage mode: 3 massage modes to choose for slow or fast
rolling massage speed.
10
Timer
•
Default spa massage time is 30 minutes.
•
Press Timer button to choose 10, 20, 30, 40, 50, 60 minutes.
•
It is recommended NOT to use the spa for more than 60
minutes continuously. Always take 10 to 15 minutes break
after each cycle.
11
Turn off power
•
Press the ON/OFF button to turn off power completely.
•
Unplug the spa from outlet.
12
Water Drainage
•
This spa has static water drainage.
•
You MUST unplug the spa from outlet before drainage.
•
After each use, before trying to drain out water, always turn
off all functions on control panel before drainage.
•
Drain the spa in bath room or put a water bucket under the
water drainage pipe; make sure no water will spill to floor.
•
Release the Drainage Pipe from its case and lower it to
bath tub or the water bucket to start draining out water.
•
Lock back the drainage pipe to the case after finishing
drainage.
Attention:
•
There may have small amount of water left inside water
container after drainage. Use a dry towel to clean up.
•
Never try to pour out water by lifting over the water
container.
13
Water Jet
•
Water Jet is located inside the water container under the
control panel.
•
Water jet surfing is stronger when the water level is lower.