EasyManuals Logo

PROSPORT EVO SERIES User Manual

Default Icon
3 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
INSTALLATION INSTRUCTIONS
85
mm EVO SPEEDOMETER W/WARNING & PEAK
WHITE/AMBER /BLUE / GREEN LED DISPLAY
1E
A BEFORE YOU START
1. Read instructions completely before installation. NOTE: It may be necessary
to reprogram your radio,
2. Install speedometer only when engine is cool and clock, etc. after reconnecting the battery.
ignition is off. 6. Make sure mounting location does not impair visibility of
3. Make sure all necessary tools, materials, and interfere with driving. Also check behind the mounting
parts are on hand. location for any wiring or components before drilling.
4. R
efer to your vehicles service manual for the location 7. When connecting electrical wire, install crimp terminals
of s
peedometer sensor port, vacuum system, and/or and make wire splices as needed. ALWAYS insulate wire
charging system. splices with electrical tape to prevent shorting.
5. Disconnect negative (-) battery cable before installing 8. Follow all necessary safety procedures for protection.
speedometer.
A
2E
A SPEED RANGE SWITCH SELECTION
1. Use the switches < 1.2.3.4.5.6.7.8.9.0> to adjust the SPEED into an approximate range.
2
.
Switch toward <0.9.8.7.6.5.4.3.2.1.> to narrow the range.
Switch toward <1.2.3.4.5.6.7.8.9.0.> to widen the range.
A
3E
A MOUNTING
You can mount your speedometer on or under the dashboard or on the center console according to your personal choice.
Determine best position for good visibility before drilling screw holes.
A
4E
A SPEEDOMETER CONNECTION
1. Connect power wire (RED) to +12V battery wire. 5. Secure lead wires along their route to prevent damage
2. Connect power wire (WHITE) to a switched +12V from sharp edges, moving parts or hot engine
circuit at fuse box, or splice into any vehicle harness components.
wire which is energized ONLY when ignition key is 6. Turn on ignition. DO NOT START ENGINE speedometer
ON (RUN) position. Lcd display should be to minimum or “0” when ignition
3. Connect power wire(BLACK) to ground, negative (-) is turned on.
battery terminal or a good chassis ground.
4. Connect power wire (ORANGE) to panel lights circuit
at fuse box, or splice into any vehicle harness wir
e
co
nnected to the panel lights circuit. .
www.prosportgauges.com email: sales@prosportpauges.com

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the PROSPORT EVO SERIES and is the answer not in the manual?

PROSPORT EVO SERIES Specifications

General IconGeneral
Size52mm (2 1/16")
DisplayLCD
Power12V DC
LightingBacklit display
RangeVaries depending on gauge type (see individual gauge specifications)
Measurement RangeVaries depending on gauge type (see individual gauge specifications)
AccuracyVaries depending on gauge type (see individual gauge specifications)
ResolutionVaries depending on gauge type (see individual gauge specifications)