Depress the button at the bottom of the Wand Rest Port
and disconnect the Power Head Hose Assembly by pulling it
straight out from the Base Assembly, and set aside.
Remove the 9 screws as indicated that are securing the Base
Assembly. Remove the the Bottom Plate.
Press and hold the Release Button to remove the Brush Roll
Cover Assembly. Turn Brush Roll 1/4 turn clockwise and
remove it.
Step 1
Step 3
Step 2
Step 4
105162/105720 Motor Replacement
Turn the machine right side up to remove the Top Cover by
lifting up on the side opposite the foot pedal.
ProGen 12 Base Assembly Replacement Instructions
WARNING
Tools needed: Phillips Screwdriver
Time needed: Total time to disassemble & reassemble with the new base should be 45 minutes or less.
866.888.2168
customerservice.proteam@emerson.com
SP6973 12/15
Use caution if using a powered screw driver, to avoid stripping screws and damaging parts.
Note: Take care to observe the 3 types of screws used in this repair, and to re-use them in the proper place.
s Carefully follow each step of these instructions to replace the base assembly. If you miss a step, you will not
complete this repair properly.
s ONLY an experienced electrical technician should implement this repair. Be aware that static discharge can
damage circuit boards. If you do not understand the special requirements for working with circuit boards,
such as defined in J-STD-001, do not attempt this repair.
s Unplug vacuum before performing repair.
Release Button
Brush Roll Cover
Assembly
Top Cover
Brush Roll
Base Assembly
Bottom Plate
To Next Page
Need help?
General
