Protection One 2GIG - User Manual

EQUIPMENT INSTALLATION
Thermostat
These instructions will guide you step by step on installing a 24vAC
Z-Wave Thermostat. If you have further questions, refer to the printed
manual that comes with each thermostat or call the dedicated
Thermostat Tech Support Line: 1-888-819-4135.
1 Turn o all power to the HVAC and all related
units (fan, etc.). This can be done at the circuit
breaker. Double check that all power is o.
2 Take o the cover of the old thermostat (most
snap or screw on). DO NOT remove the wires
yet. Carefully note the colors of the existing
wires and what letter they correspond to on the
existing thermostat.
Power Grid
status
indicator
top cover
Touch screen
Wire
terminals
Mode
button
button
MENU
Reset
button
HVAC
selections
switches
bottom
cover

Summary

Thermostat Installation

Preparation and Safety

Steps to turn off power to HVAC units, remove the old thermostat cover, and label existing wires.

Wiring and C-Wire Identification

Guidance on labeling wires, checking for a C-wire, and connecting wires to the new thermostat terminals.

Mounting and Power Restoration

Instructions for feeding wires, mounting the thermostat, checking guidelines, and restoring system power.

Protection One 2GIG Specifications

General

Brand	Protection One
Model	2GIG
Category	Thermostat
Language	English