- 3 -
Before you begin
Important: Read all instructions carefully. Assemble the unit in
accordance with the steps in the manual. Lay out all parts
on the floor and check if you have all the parts are included
before beginning assembly. In case of a discrepancy,
please call the customer service department of the store for
help.
Replaced defective components immediately and keep the
Equipment out of use until repair.
Note: some parts may be factory pre-assembled.
INTRODUCTION / SAFETY GUIDELINE / INFORMATION
Note: Do not plug to power supply before machine is fully
assembled. Input power supply specification depends on local
electricity supply, and a proper transformer may be needed.
DC transformer spec.: Input: 220-240V (100-120V) ~ 50Hz (60Hz)
Output: 6V 1.0A
The most susceptible to wear parts are
Bearing / Belt
Tools required for assembly
Open wrench 14mm
Allen wrench
Screw driver
To Next Page
Loading...
