123
• If you had enabled the Steering Linkage switch in 360 setting menu, when you turn on the
turn left/right light, it will enter into 360 camera with front left/right view.
Exit 360 Camera View:
• Click back button in the top right corner of the screen.
• Push the 360 hardware button again.
• When in no R gear, and the speed over 30km/h.
• Exit R gear, and back to P gear, will exit 360 in 5s.
1. Exit : Exit the 360 camera.
2. Dynamic auxiliary line switch: You can click the button to open/close the auxiliary line
display.
3. View switch: you can switch between the 2D view and 3D view.
In 2D view: you can click cameras on the side of the 3D vehicle to switch between the
front, rear, left, and right views.
In 3D view: you can click cameras on the side of the 3D vehicle to switch between the
front, rear, left, and right, front-left, rear-left, front-right, rear-right views. And you can also
rotate the vehicle model on right 3D view area to look any view angel.
4. More Multiview: You can choose Rear Left-Right views , Front Left-Right views , Rear
wide view , and Front wide view.
5. 360 Settings: You can set the 3D surround activated, Steering Linkage Switch, and
Transparent car mode.
Multimedia system(typeⅡ)
To Next Page
Loading...