27
We guarantee appliances in accordance with sta-
tutory/country-specific regulations (proof of
purchase by invoice or delivery note).
Damages attributable to normal wear and tear,
overload or improper handling will be excluded
from the guarantee.
In case of compliant please send the machine, un-
dismantled, to your dealer or the Service Centre
for electric power tools.
We declare under our sole responsibility that this
product is in conformity with the following stan-
dards or standardization documents:
EN 50 144-1, EN 55 014-1, EN 55 014-2,
EN 61 000-2-3, EN 61 000-3-3,
according to the provisions of the regulations
89/336/EEC, 98/37/EC
Manfred Kirchner
Subject to change
Defects and their removal
Defect Cause Removal
The machine will not run
There is no current supply
Check safety fuses and supply
wires
Worn brushes Replace brushes
Stuck switch Press a safety fuse
When overloaded Check safety fuses
The cut is not clean, the chain
goes to the side
Too big shift into the cut Reduce the shift
Blunt tool
Sharpen the chain, or replace it
with a new one
The chain is not properly
sharpened Replace the chain with a new one
Cutting without a stop gui-
dance Use the stop guidance
Required big power to shift the
machine into the cut
Supporting area of the
sleigh is dirty
Clean it and lubricate it with gliding
wax
Blunt tool
Sharpen the chain, or replace it
with a new one
Different qualities of wood
Adjust the size of the shift to the
cut
Too big shift for the cut Reduce the shift
The chain is not lubricated Blocked lubricating chan-
nels of the guide reglet Clean the guide reglet
Defected dose oil pump
Replace the pump (in an authori-
sed service workshop)
Empty oil tank Replenish chain oil
Inner oil channels of the
machine are blocked
Clean the machine (in an authori-
sed service workshop)
Guarantee
Declare of conformity
kniha_Narex_CPP380.book Seite 27 Mittwoch, 31. Oktober 2001 11:53 11
To Next Page
Loading...
