Protool WCP-32 User Manual

9
GB
Wall Chaser WCP 32 – original
instruction
Table of contents
1 Symbols .............................................. 9
  ................................. 9
3 Application ........................................... 9
4 Controls .............................................. 9
5 Safety instructions ................................ 9
5.1 Safety precautions for work procedures
comprising abrasive cutting .................. 10
5.2 Further safety precautions for work
procedures comprising abrasive cutting ... 11
5.3 Emission levels ................................... 11
6 Tool clamping ..................................... 12
6.1 Installation of diamond discs ................ 12
6.2 Slotting with four discs ........................ 12
6.3 Uninstallation of diamond discs ............. 12
6.4 Adjusting the cutting depth .................. 12
7 Dust exhaust ...................................... 12
8 Commissioning ................................... 12
8.1 Smooth start-up ................................. 13
8.2 Overload protection ............................. 13
8.3 Thermal overload protection ................. 13
9 Maintenance ....................................... 13
10 Environmental Protection / Disposal ........ 13
11 Warranty ........................................... 13
12 Declaration of Conformity .................... 14
1 Symbols
Double insulation
Warning of general danger
Risk of electric shock
Use protective goggles!
Wear ear protection!
Wear a dust mask!
Use protective gloves!
Read the instructions
Not to be included in municipal refuse
 Advice or tip
 
Voltage 220 – 240 V
Frequency 50 – 60 Hz
Input power 1600 W
Idle speed 7200 min
–1
Weight 4.9 kg
of discs 125 mm
Depth of groove 0 – 32 mm
Width of groove
- with one disc 2.6 mm
- with two discs 7 – 35 mm
Width of spacer rings 2.5; 5; 10; 15 mm
Protection class II /
3 Application
This tool is intended exclusively for cutting grooves
and dividing of materials, especially concrete,
brickwork, tiles, etc., without the use of water. For
materials that produce dust or fumes hazardous to
health during processing, use an exhaust system in
line with regional safety regulations (see the Use
of higher class exhausters – M, H).
The user is responsible for any use not in compli-
ance with the intended use.
4 Controls
[1-1] Switch
[1-2] Switch unblocking
[1-3] Cutting depth regulating wheel
[1-4] Slide unblocking button
[1-5] Rotation direction arrow
[1-6] Exhaust attachment
[1-7] Auxiliary handle unblocking
[1-8] Auxiliary handle
[1-9] Load indication light
[1-10] Quick-clamp nut
[1-11] Shutter
[1-12] Spacer rings
[1-13] Diamond discs
Not all of the accessories illustrated or described
are included as standard delivery.
5 Safety instructions
WARNING!
Read all instructions. Failure to follow all instruc-

and/or serious injury. The term “power tool” in all
of the warnings listed below refers to your mains-
operated (corded) power tool or battery-operated
(cordless) power tool.

Protool WCP-32 Specifications

General

Brand	Protool
Model	WCP-32
Category	Power Tool
Language	English