To Next PageTo Next Page
Need help?Do you have a question about the Protos Plastic 500 and is the answer not in the manual?
Essential safety guidelines for operating and adjusting the RC helicopter, emphasizing caution.
Lists necessary tools for assembling the RC helicopter, including screwdrivers, pliers, and epoxy.
Details the necessary RC transmitter, receiver, satellites, and battery packs for the helicopter.
Guidance on selecting motor pinion teeth based on fly style and battery type for optimal performance.
Assembly instructions for Bag-A, focusing on servo frame and related components.
Assembly instructions for Bag-B, detailing the guide pulley and pin components.
Assembly of Bag-B, including motor mount and frame connections with caution notes.
Further assembly of Bag-B, connecting main frame parts with screws and nuts.
Assembly of Bag-B, focusing on attaching landing gear struts and skids.
Assembly of Bag-B, installing the canopy stand and anti-swashplate spin components.
Assembly of Bag-C, covering the main shaft, lock, and belt installation.
Assembly of Bag-C, focusing on the swashplate and ball connections with length guidance.
Assembly of Bag-C, connecting servos to the swashplate using rods.
Assembly of Bag-D, focusing on washout pin and low flybarless hub components.
Continued assembly of Bag-D, detailing the washout uniball arm and ball connections.
Assembly of Bag-D, installing spindle spacer and damper main head components.
Assembly of Bag-D, connecting the head link components with hex screws and nuts.
Assembly of Bag-E, detailing guide pulley and boom case connections.
Assembly of Bag-E, installing tail servo holder and boom assembly with specific orientation.
Assembly of Bag-F, focusing on tail box, guide pulley, and tail shaft components.
Assembly of Bag-F, connecting the tail uniball hand components.
Assembly of Bag-F, installing tail pitch lever and related screws with specific tightening instructions.
Assembly of Bag-F, attaching the tail blade holder and spindle with thread lock.
Assembly of Bag-F, installing tail blades with caution on screw tightening.
Assembly of Bag-G, attaching tail boom braces and horizontal fin components.
Assembly of tail control rod fitting using slow curing epoxy.
Installation of the motor using M3x8 hex screws with thread lock.
Attaching the motor adapter using grub screws, ensuring alignment with the motor shaft flat spot.
Installation of the motor pulley, ensuring it spins freely clockwise.
Installing the battery, ESC, and canopy using O-rings for secure placement.
Guidance on adjusting belt tension properly on both sides for optimal helicopter performance.
Installation of the main blades using M3x23 hex screws and M3 nylon nuts.
General